Had to replace the pump, also Amazon and only minor problems since. The Honda engine is holding up great! Yep, have owned this same p/w since 4/08, honda engine, starts on first pull EVERY time. Used it about 15-20 hrs/yr before the pump seized up this spring. I will think about other brands before Troy Bilt again.'īought the 020344-2 at Lowes, with Honda engine, 2/28/09. I thought Troy Bilt actually built good stuff. The cost of a new pump is almost 2/3rds the cost of the whole pressure washer. QUOTE=anonymous 48404After using this pressure washer for about 15 to 20 hrs.(not continuously, over two yrs) the pump seized up. However, now thanks to these new nozzles that is not a problem at all! These nozzles are so easy to change and. The nozzles would stick in the pressure washer or not want to come out. Because of this, the nozzles have been harder for my mom, sisters, and I to change. Although we try to keep it that way, when my dad washes the equipment that is covered in mud and grease, it gets all over the pressure washer. With that being said, our pressure washer is not the cleanest by any means. We love using it to wash our cars, clean the dog kennels, and my dad uses it a lot to clean his heavy equipment. I was so happy to come across these replaceable pressure washer nozzles! My family has had the pressure washer we have for a while now and we use it all the time. Would a gun screws onto the house, measurements are my hose is 3/8 of an inch, with quarter inch quick connects, these fittings are also called M22 fittings. I had a quick connect to take off from the pressure washer at the machine, and I also had a quick connect to take off. I have only used it 2 times though! I have my standard 25 foot hose and I also have a 50 foot hose for extension hose, both hoses on both ends have a female ends, so all I did is screw in the two male ends to each side of the house and then the two female ends into the pressure washer and the pressure washer gun, now I use 2 of these but after I screwed all four ends in. Does not leak now, and fits just fine.One part screws on the machine, one part on the hose, and the 3rd part connects them together. But if you line up the thread and use a wrench to get an extra turn on it, it works. Mine did leak a little and did not pop right in place.

HOWEVER, I think the issue was that they did not have instructions and did not try to use pliers to snug it up. I did not think it would work well with it either. I did not notice that other reviewers said this would not work with the Snow Joe Sun SPX3000. Did your Troybilt model 020344 power washer, gas break down? SAVE money and repair it yourself! We are here to help - over 49 genuine Troybilt repair and. Free repair help to fix your Troy-Bilt pressure washer.

Kenwood tk 760hg programming software